Instruments/Zeiss-Elyra-7.md

@@ -24,22 +24,22 @@ Use a yellow marker pen slide with a coverslip and a slide with beads (100nm Tet
 3. Focus on the lattice pattern and take a ‘Snap’
 4. Go to ‘Graphics’ and draw an arrow/line across the pattern
 
-![Graphics](uploads/a5c85c9914eee4c16a20224af2c69ba5/Graphics.jpg){width=40%}  
+![Graphics](uploads/a5c85c9914eee4c16a20224af2c69ba5/Graphics.jpg){width=50%}  
 ![Grid](uploads/a1e938d78726d18e1c3285c271ab996e/Grid.jpg){width=100%}
 
 5. Make sure that the ends of the arrow are placed in the same line across the image, switch off the interpolation
 
 ![Grid_left](uploads/a87bec7600fdf31fe9b0065a2f23a0f4/Grid_left.jpg){width=30%} ... ![Grid_right](uploads/662b603921d038da3c9954f49d771493/Grid_right.jpg){width=27%}  
-![Dimensions](uploads/b3c918277fc692ab3a6e923208c0dc5a/Dimensions.jpg){width=40%}
+![Dimensions](uploads/b3c918277fc692ab3a6e923208c0dc5a/Dimensions.jpg){width=50%}
 
 6. In ‘Graphics’ activate ‘M’ (measurement) and check the angle 
 
-![Graphics_measure](uploads/8de9fc67bee34262465186b8022c2c1f/Graphics_measure.jpg){width=35%}
+![Graphics_measure](uploads/8de9fc67bee34262465186b8022c2c1f/Graphics_measure.jpg){width=50%}
 ![Grid_angle](uploads/fbea05bb3dba5378465ed6d94f36d71a/Grid_angle.jpg){width=40%}
 
 7. Go to ‘Maintain’, and drag out the ‘Dual Camera Adapter Alignment’ tool
 
-![Maintain](uploads/4cd5fe821496c21336794064bfb57643/Maintain.jpg){width=40%}
+![Maintain](uploads/4cd5fe821496c21336794064bfb57643/Maintain.jpg){width=50%}
 
 8. Tick 'Calibration pattern'