Instruments/Zeiss-Elyra-7.md

@@ -79,7 +79,7 @@ Always make sure that the system is back at 28.5°C and the CO<sub>2</sub> is of
 
 </summary>
 
-- Move to Acquisition Tab
+- Move to the Acquisition Tab
 - In the Imaging Setup window click on +Lattice SIM: This will create a Track1, if you need more tracks click additionally on +Lattice SIM
 - Activate respective lasers (405, 488, 561 and 642 nm are available)
 - In the SIM Grating changer 'Optimal Grating' should be checked
@@ -124,7 +124,7 @@ Example of a Track2 with 405 nm laser activated, using DL QUAD 1 SBS LP 560 beam
 
 <summary>
 
-### `Setting up TIRF`
+### `Setting up TIRF (old)`
 
 </summary>
 
@@ -144,7 +144,7 @@ Example of a Track2 with 405 nm laser activated, using DL QUAD 1 SBS LP 560 beam
 
 </details>
 
-## Dual-Camera Alignment & Colocalization Analysis
+## Dual-Camera Alignment & Colocalization Analysis (old)
 
 Camera Alignment has to be checked/done before **each experiment** using both cameras and for **each used filter** in the camera link and for **each used objective** individually. It has to be done again if the camera was pushed by accident, or if the cover of the camera link has been opened.
 
@@ -152,7 +152,7 @@ Camera Alignment has to be checked/done before **each experiment** using both ca
 
 <summary>
 
-### `Camera Rotation`
+### `Camera Rotation (old)`
 
 </summary>  
 
@@ -189,7 +189,7 @@ Use the yellow marker pen slide with a coverslip (on the desk next to the lens c
 
 <summary>
 
-### `Camera xyz-Alignment`
+### `Camera xyz-Alignment (old)`
 
 </summary>
 
@@ -219,7 +219,7 @@ Use the yellow marker pen slide with a coverslip (on the desk next to the lens c
 
 <summary>
 
-### `Channel Alignment`
+### `Channel Alignment (old)`
 
 </summary>
 
@@ -274,7 +274,7 @@ Channel Alignment has to be done before **each colocalization experiment** using
 
 <summary>
 
-### `Data Handling and Transfer`
+### `Data Handling and Transfer (old)`
 
 </summary>