Instruments/Zeiss-Elyra-7.md

@@ -10,7 +10,7 @@
 
 ![PXL_20240320_095753421](uploads/6243a65ae74f7d9c37bec3fa7fe80a35/PXL_20240320_095753421.jpg)
 
-2. If at any point during your experiment a loud beeping sound goes off, first check the CO2 sensor (and leave the room if the sound is coming from the sensor). If not, the noise is coming from the cooling system behind the Elyra and you need to [refill the cooling liquid](Maintenance/Elyra 7#Cooling-System). 
+2. If at any point during your experiment a loud beeping sound goes off, first check the CO2 sensor (and leave the room if the sound is coming from the sensor). If not, the sound is coming from the cooling system behind the Elyra and you need to [refill the cooling liquid](Maintenance/Elyra 7#Cooling-System). 
 
 3. Choose the correct objective you want to use for imaging (via the touch panel, menu point 'Microscope') and press 'Load position' to bring the objective down to its lowest position.
  
@@ -27,7 +27,7 @@ For the front flap you will need to open (to move flap up) and tighten (to keep
  
 8. All doors on the incubator need to be properly closed before you can start imaging in the Acquisition tab as otherwise the interlock is not released and the lasers will not be active. You can check for this: if one of the LEDs on the main controller is blinking, one of the laser interlocks has not been recognized. Unfortunately, there is no feedback which interlock is affected, so you need to check them all and potentially, open and close all doors again or even lift the condenser and put it back down.
 
-![PXL_20240320_091545142](uploads/771b95ca313e0a923254dbf26539bca8/PXL_20240320_091545142.jpg){width=54%} ![PXL_20240320_092901039](uploads/abfc3c39fba668f2f6dfff165d7c3a91/PXL_20240320_092901039.jpg){width=45%}
+![PXL_20240320_091545142](uploads/771b95ca313e0a923254dbf26539bca8/PXL_20240320_091545142.jpg){width=50%} ![PXL_20240320_092901039](uploads/abfc3c39fba668f2f6dfff165d7c3a91/PXL_20240320_092901039.jpg){width=48%}
 
 ## Environmental Control
 [Zeiss_Elyra_Environmental_controls_01.pdf](uploads/9e4a1088f421fd1742a2dd0076f3a89a/Zeiss_Elyra_Environmental_controls_01.pdf)
@@ -119,7 +119,6 @@ Channel Alignment has to be done before **each colocalization experiment** using
 
 ## Shutdown
 
-Shut-down
 - Close Zen Black
 - Press the Load position on the touch panel
 - Clean immersion objectives with lens cleaning paper