| ... | ... | @@ -61,13 +61,12 @@ Finally add the heated lid - it should fit exactly over the heated insert. The f |
|
|
|
|
|
|
|
**Be careful when lowering the condenser, as it could be in a too low position, which would lead to the condenser crashing into the heating lid!**
|
|
|
|
|
|
|
|
In the software, move to the "Incubation" Tab (in the right hand panel in ZEN) and tick the heated lid and one of the inserts (the one you use) and the components will be heated to the selected temperature. Finally tick "Co2 Small V", assuming you need to supply Co2.
|
|
|
|
In the software, move to the "Incubation" Tab (in the right hand panel in ZEN) and tick the heated lid and one of the inserts (the one you use) and the components will be heated to the selected temperature. Finally tick "CO<sub>2</sub> Small V", assuming you need to supply Co2.
|
|
|
|
|
|
|
|
**Inc PM**: lid
|
|
|
|
**H Insert P**: insert for slides/ibidi dishes
|
|
|
|
**H Insert M**: insert for 35mm dishes
|
|
|
|
|
|
|
|
O<sub>2</sub>
|
|
|
|
|
|
|
|
|
|
|
|
|
| ... | ... | |
